1_1_PP Hardware EN

Componente Hardware Passport

• Familia 7k• Familia 15k• Bus• LED-Status

Ersteller: Enrico Lock, TTO-SWDatum: 27.04.23

27.04.23 Seite 2 Enrico Lock, TTO-SW

7k-Passport (Seria 7480)7k-Passport (Seria 7480)

screenshot von der MDM

ATMAS types of cards used in the 7k-Passport► Control Processor = CP

Slot 0 and Slot 15 (each CP has one HDD)

► Function Processor = FPSlot 1- Slot 14

• 32pE1Msa (Multi service access)

• 32pE1MsaStp• 2pOC3SmAtm2 (optische STM1-Ports)

• 2pSTM1eAtm• 2pSTM1elCh (Channelized-Karte)

► Power the shelf can be equipped with three power supplies

► Fan


Trafficcards (FPs) des 7k-PassportsTrafficcards (FPs) des 7k-Passports

32pMsaE1Stp (NTNQ72)Sevices: FrameRelay, CES, ATM, IMA, IP over FrameRelay, Trunk

2pOC3SmAtm2 (NTNQ66)Services: ATM, IP over ATM, Trunk

2pStm1eAtm (NTNQ90)Services: ATM, IP over ATM, Trunk

2pStm1eCh (NTNQ96)Services:SDH-Multiplex, ATM, CES, IMA, Trunk, IP over ATM

Bildquelle: Nortel Networks


n+1 protection MSA-Karte n+1 protection MSA-Karte

Termination Panel

Quelle Karten- und Panelgrafik : Nortel Networks

spare card

main card main card


1+1 protection STM1el-Karten 1+1 protection STM1el-Karten


Schematic diagram for wiring of electrical equipment protection STM1 cards with termination panel.Note the proper wiring of the control cable (dashed line).


MainA MainB

MainC Spare

TX RX

TX RX

MainATX RX

TX RX

LineATX RX

TX RX

MainBTX RX

TX RX

LineBTX RX

TX RX

MainCTX RX

TX RX

LineCTX RX

TX RX

Spare

3+1 protection for 2pSTM1eAtm and 2pSTM1elCh 3+1 protection for 2pSTM1eAtm and 2pSTM1elCh

Termination Panel

Quelle Karten : Nortel NetworksQuelle Panel: Enrico Lock

spare card

main card (mainA) main card (mainB)

Liniile punctate reprezinta cablu TX/RX bidirectional

top row are the coax jacks for port 0? bottom row are the coax connectors for Port 1

Control


15k-Passport15k-PassportTipuri de cadrui prezente in PP 15K

► Control Processor = CPSlot 0 and Slot 1 (each CP has one HDD)

• CPeE

► Function Processor = FPSlot 2- Slot 15

• 16pOC3PosAtm• 4pOC3SmIrAtm

► BIP (Breaker Interface Panel) Power (-48V / bis 100A)Consists of two BIM (Breaker Interface Module) for a 15k shelf? Or 4 BIMs 15k for 2-Shelf 19'' rack.

screenshot von der MDM


15k-Passport15k-Passport

► Fan

► two Fabrics = replaceable bus

► external clock input

► MAC-Address Card

► Power Interface moduls


Trafficcards (FPs) des 15k-Passport

16pOC3PosAtm (NTHW44 oder NTHW48)

Sevices: ATM, IP over ATM, Trunk

Note:Is an SDH port is failed,may be faulty SFP.



Overview of Interfaces and Protection

Card Passport Type Interfaces Protection *CP 7k-PP und 15k-PP Ethernet

V.241+1

32pE1Msa 7k-PP 32 E1-Port n+1

32pE1MsaStp 7k-PP 32 E1-Port1 Stm1-Port (Opt. / unstructured)

n+1 (für E1en)keine (für STM1)

2pOC3SmAtm2 7k-PP 2 Stm1-Port Opt(Opt. / unstructured)

keine

2pSTM1eAtm 7k-PP 2 Stm1-Port(elect. / unstructured)

n+1 bis max. 3+1(bisher 1+1)

2pSTM1eCh 7k-PP 2 Stm1-Port(elect. / structured)

n+1 bis max. 3+1(bisher 1+1)

16pOC3PosAtm 15k-PP 16 Stm1-Ports(Opt. / unstructured)

keine

*The column "Protection" describes the capabilities of the hardware protection. ?It is also possible to protect circuits by means of software,? for example, over optical lines LAPS (linear Automatic Protection Switching)


Hardware Printoutssde230> d sh card/* insertedCardType, cardType ==|============================================ | inserted cardType | CardType ==|=====================(1)=========(2)======== A|SDE230 Shelf Card/0 CP CP B|SDE230 Shelf Card/1 2pSTM1eCh 2pSTM1eCh C|SDE230 Shelf Card/2 none none D|SDE230 Shelf Card/3 2pSTM1eCh 2pSTM1eCh E|SDE230 Shelf Card/4 none none F|SDE230 Shelf Card/5 2pSTM1eCh 2pSTM1eCh G|SDE230 Shelf Card/6 none none H|SDE230 Shelf Card/7 2pSTM1eCh none I|SDE230 Shelf Card/8 none none J|SDE230 Shelf Card/9 32pE1Msa 32pE1Msa K|SDE230 Shelf Card/10 none none L|SDE230 Shelf Card/11 2pOC3SmAtm2 2pOC3SmAtm2 M|SDE230 Shelf Card/12 none 2pOC3SmAtm2 N|SDE230 Shelf Card/13 2pOC3SmAtm2 2pOC3SmAtm2 O|SDE230 Shelf Card/14 2pOC3SmAtm2 2pOC3SmAtm2 P|SDE230 Shelf Card/15 CP CP ==|============================================16 ok Jan 30/06 16:38:39

Meaning of the parameters: insertedCardType … indicates the type recognized by the Passport CardcardType … shows the configured card type

SDE229> d -no sh text Shelf commentText = MSC Kornwestheim (15k)ok 2006-01-30 16:53:25.52

Comment text with the location of the passport

State when the card is inserted but not yet configured

State when the card is not recognized by the system (eg card has locked up or is defective)


Meaning of the LED states

LED Status State

OFF Card is dead

RED Card performs self-testDefective condition longer than 30 sec

Slowly flashing red

Card waiting for loading the software

Rapidly flashing red

Card loads Software

Slowly flashing green

Card is loaded but not activated(eg after a lock card "lock sh card / 1")

Blinking green rapidly

Card is in Sparingmode

Permanent green Card is active and working

Permanent amber Hardware of the card is o.k. But? Card can not work

7k

15k

LED


Bus

Bus/x

Bus/y

For 7k Passport family of the bus "bus" is and is inextricably linked to the shelf. ? If the bus is broken needs to be replaced, the entire shelf

In the 15k Passport family consists of two bus "Fabric Card" s, which can be replaced separately from each other

The bus in the Passport is designed with redundancy

Traffic is distributed on the two buses, ie if the sum of the utilization of bus / x and bus / y is> 100%, then the fault of a bus traffic affecting

sde246> d sh bus/*==|======================================================= #| SDE246 SDE246 | Shelf Bus/x Shelf Bus/y ==|============================(A)===========(B)========== 1|adminState unlocked unlocked 2|operationalState enabled enabled 3|usageState active active 4|availabilityStatus 5|proceduralStatus 6|controlStatus 7|alarmStatus 8|standbyStatus notSet notSet 9|unknownStatus false false 10|busTapStatus 0 ok ok 11|busTapStatus 1 ok ok 12|busTapStatus 2 none none 13|busTapStatus 3 ok ok 14|busTapStatus 4 none none 15|busTapStatus 5 ok ok ~~~ 25|busTapStatus 15 ok ok 26|clockSource activeCP activeCP 27|clockSourceStatus activeCP ok ok 28|clockSourceStatus alternate notApplicable notApplicable29|utilization 2 % 4 % ==|=======================================================2 ok Jan 08/08 16:00:39


„restart“ und „reset“

• restart sh card/7LED Status: red permanently

Slowly flashing green green flashing quickly

- The card performs a self-test (inference from the LED state)- Software reloaded

• reset sh card/7LED Status: red permanently

flashing red green flashing quickly Slowly flashing green

- Reset the hardware - Perform a self-test cards- Reloading the software


Instructiuni importante

• reset sh…reboot the passport (traffic affecting)

• reset sh card/9…reboot der card in Slot 9 (traffic affecting)

• d lp/* main,spare,activ …shows the Protection Configuration: Main card protection card and which card is active

• switch lp/3…switch the card in slot 3 on the protection card; run the command again to switch back, if switching is not executable "switch-force lp / 3"

• lock –force sh card/3…Lock card (traffic affecting; LED cards - slowly flashing green)

1_1_PP Hardware EN

Documents

Transcript of 1_1_PP Hardware EN