117489267 4 Using Ncs to Change Vo

BMW GroupService TechnicalV4-US-A-21Paul Labrie /Klaus Lanny04/13/2005

Before NCS can be used a Profile must be loaded.

Select File/Load Profilfrom top menu bar


Select “Expertmode” then OK


Once a profile is loaded the bottom buttons become

selectable

Select F1 to read vehicle data first.


Select F3 to read FA from ECU.This needs to be done before any

coding can be performed.


Select the model you are working with.

For this example “E65”Select OK once highlighted


Choose the ECU to read the Vehicle Order from.

In this example “CAS”Select OK


The Model, VIN and VO should then be displayed

Select “F2” to modify VO


Select the model you are working with.

For this example “E65”Select OK once highlighted


Verify that the VIN is correct.Note: last digit is a checksum

Select OK

BMW GroupService TechnicalV4-US-A-21Paul Labrie /Klaus Lanny04/13/2005 “Enter FA”

SA codes must begin With $

Service CodesMust begin

With +

Enter SA or Service codeThen select

“Add”


ExampleEnter $655

Select “Add”Scroll downTo check


ExampleEnter +EVERSelect “Add”Scroll down

to check.Select OK


After you have successfully changed the VO you will see this

screenSelect F6 (Back)


Select F4Process ECU


Select the CAS


Select F2Change job


Select “FA_WRITE”


Verify Jobname is“FA_WRITE” and CAS is

ECU selected

Select F3Execute Job


Select F1Change ECU to select LM

This will ensure that new VO is written into CAS and LM


Select “LMA”


Select F3

Execute Job

Verify Jobname is“FA_WRITE”

and LMA is ECU selected

117489267 4 Using Ncs to Change Vo

Documents

Transcript of 117489267 4 Using Ncs to Change Vo