1 © 2009 ZelFlex QR 266x380 with adapter Step by Step User Guide Version 1.02.

1 © 2009

ZelFlex QR 266x380 with adapter

Step by Step User GuideVersion 1.02

2 2


• Loosen the marked screws, located within the slot.

Loosen just the screws from the one side of the adapter.

• Use Allen (Hex) key no.: 5

3 3


•Place stretching frame over the adapter.

4 4


• Insert new screws together with the washers in the slots at all four sides.

• Tighten them into the groove nuts, inserted in the longer profile of the stretching frame.

• Use Allen (Hex) key no.: 5

NOTE:

ZelFlex QR 266x380 frames have to be equipped with the groove nuts, inserted on the both longer profiles of the frame. In case the nuts are not in that positions, contact us.

5 5


• Tighten all four screws which fix the stretching frame.

6 6

• Tighten the screws of the sliding rails.


7 7


•After the adapter and stretching frame are assembled the stencil (metal or polyimide foil) can be inserted.

•To insert the stencil follow instructions in ZelFlex QR – User manual or ZelFlex QR - StepByStepUserGuide

8 8


ZelFlex QR 266x380 frame is specially designed for direct clamping A4 polymer stencils.

9 © 2009

Zelflex QR 266x380 with adapter

Step by Step User Guide, version 1,02, september 2010

Prepared by:

LPKF Laser & Elektronika d.o.o. · Polica 33 · 4202 Naklo · Slovenia

1 © 2009 ZelFlex QR 266x380 with adapter Step by Step User Guide Version 1.02.

Documents

Transcript of 1 © 2009 ZelFlex QR 266x380 with adapter Step by Step User Guide Version 1.02.