1 2 3 4 5 - quidel.com · Transfer 50 µL to each Reaction Tube. Insert swab into Lysis Buffer Tube...
1
95°C Lysis Block Workflow Tray Transfer Rack Kit Contents Equipment Reaction Tubes Dilution Buffer Tube Lysis Buffer Tube Assay Procedure – Heat Lysis VORTEX 5 seconds VORTEX 5 seconds Rehydrate by pipetting up and down a minimum of 5 times. Heat for 5 minutes at 95°C. Close lid tightly and proceed to next step. Transfer 50 μL to each Reaction Tube. Insert swab into Lysis Buffer Tube and swirl for 10 seconds. PCM301001EN00 (12/16) Amplification and Detection Add 50 μL to Dilution Buffer Tube. 1 3 4 2 5 Solana Instrument 1 3 4 2 5 Close the lid and select appropriate assay protocol. Run complete in 25 minutes. Review results. 6 Setup the Workflow Tray with patient samples, Lysis Buffer Tubes, Dilution Buffer Tubes, and Reaction Tubes. 6 8 7 Use the Transfer Rack to lift Reaction Tubes from the Workflow Tray. Lower the Reaction Tubes into Solana. Release the Reaction Tubes from the Transfer Rack by pulling the Transfer Rack toward your body. Procedure Card GAS Assay Study the Package Insert thoroughly before using this Procedure Card. This is not a complete Package Insert.
Transcript of 1 2 3 4 5 - quidel.com · Transfer 50 µL to each Reaction Tube. Insert swab into Lysis Buffer Tube...
95°CLysis Block
WorkflowTray
TransferRack
Kit Contents Equipment
ReactionTubes
DilutionBufferTube
LysisBufferTube
Assay Procedure – Heat Lysis
VORTEX5 seconds
VORTEX5 seconds
Rehydrate by pipetting upand down a minimum of
5 times.
Heat for 5 minutesat 95°C.
Close lid tightly andproceed to next step.
Transfer 50 µL to eachReaction Tube.
Insert swab intoLysis Buffer Tube
and swirl for 10 seconds.
PCM301001EN00 (12/16)
Amplification and Detection
Add 50 µL to Dilution
Buffer Tube.
1 3 42 5
SolanaInstrument
1 3 42
5
Close the lid and selectappropriate assay protocol.
Run complete in 25 minutes.
Review results.
6
Setup the Workflow Tray withpatient samples, Lysis BufferTubes, Dilution Buffer Tubes,
and Reaction Tubes.
6 87
Use the Transfer Rack to liftReaction Tubes from the
Workflow Tray.
Lower the Reaction Tubesinto Solana.
Release the Reaction Tubesfrom the Transfer Rack bypulling the Transfer Rack
toward your body.
Procedure Card
GAS Assay
Study the Package Insert thoroughly before using this Procedure Card. This is not a complete Package Insert.
