00 Sheet and Answer Material Removal Prof.alaa El-Hakim Ahmedawad
8
-
Upload
ahmed-awad -
Category
Documents
-
view
6 -
download
0
description
Metal RemovalSelect the proper tool materials, tool geometry and cutting values for each of the following machining cases for higher productivity and minimum cost. ( Assuming sufficient m/c tool rigidity and power)1- Rough & finish turning of St37, St50, St60, iX^St (& MCI2- Rough & finish turning of GG20, GG50, C35; f\l ,3- Rough turning of super hard alloys.4- Finish turning of AJ-Mg-Si i ^ -5- High precision finish turning of Al-Si- f6%6- Shaping of G20.7- Machining of stainless steel 18-10 shafts.8- Form turning on automatic & semiautomatic machines, of fate Cutfmy -9- Drilling 10 mm in St50, GG20, C45, C45 ( # f$RC )10- plain milling St37, (60 cutter, 8 teeth ).11- Face milling of St37, Of 100 cutter, 6 teeth ).12- Drilling 61.5 mm in hr&nzc
Transcript of 00 Sheet and Answer Material Removal Prof.alaa El-Hakim Ahmedawad
