€¦ · Web viewIn a word, the DMX Address is the starting channel on DMX Console. Press "OK" to...
Transcript of €¦ · Web viewIn a word, the DMX Address is the starting channel on DMX Console. Press "OK" to...
Work with SD card(offline)
Step1. Connect lights, slave controller and
H803TC like the following image.
I connect H801RC to NET1 and NET2, you can also just
connect H801RC to NET1.
If you want to control for example WS2812B strip,
just connect GND, DI on strip to GND, DAT on slave
controller.
Step2. Download and Install LED Build Software
In this mode(SD card mode), you need LED Build
Software.
LED Build Software Download Link:
https://drive.google.com/open?id=1DUF7TwbdJ-
k_RLnPPTMX3rhHBc1x6EYA
LED Build Software Tutorial Video(especially for
H803TC): https://drive.google.com/open?
id=1scuoAgFEXGQSubIM6dblVSMdj20xuBy7
Step3. Program in LED Build Software
In the video, I show H803TC connects one
H801RC, if you connect more, same theory.
Basically, you can learn everything you need to
make H803TC work in the video. The following is
some text explanation.
Place Pixels
Assume only one H801RC is connected to H803TC
Light Setting
Tips
(1) . In sculpt window, you can press “Ctrl” as
dragging a rectangle from a point, you can set
size as you wish.
(2) . when you choose color in color plate, click
one color, press “Ctrl” as clicking another
color(or the same color), one color will gradually
change to another color.
Step4. Output controller data and put it into SD
card
Step5. Configure H803TC with 4 buttons
Power H803TC on
Long press "MENU" button to switch to English
Set DMX Address for H803TC
This function is used when H803TC is connected to
DMX console
For example:
If DMX Address is 1, you can use channel 1,2,3 on
DMX Console to switch files, change speed and
brightness.
If DMX Address is 3, you can use channel 3,4,5 on
DMX Console to switch files, change speed and
brightness.
In a word, the DMX Address is the starting channel on
DMX Console.
Press "OK" to start addressing.
Work with PC(online)
Step1. Connect lights, slave controllers and
H803TC like the following image.
Step2. Download and Install LED Studio
Software
In this mode, you will need LED Studio Software.
LED Studio download link:
https://drive.google.com/open?
id=1ZGqPM7_kZj68LsAZMEL-NeiDO7B9Sbqe
Step3. NET2 Setting
In online mode, NET2 transmits data received from PC
to NET1.
Step5. Program in LED Studio Software
Basic software workflow
1. Place Pixels
For example there are 4 slave controllers(H801RC)
connected to H803TC, 8 ports of H801RC are all
connected to leds.
In LED Studio
2. Slave Setting
4. Control DMX512 chip lights
H803TC can control H801RC, H802RA two kinds of
slave controllers(they all support DMX512 protocol),
but by using H803TC + H802RA, you can set DMX
address for DMX512 chips.
Take TM512 strip for example:
Step1. Set them up