...INTRODUCTION XPROG-m Errata Sheet 001 This errata provides information applicable to the...

1
INTRODUCTION XPROG-m Errata Sheet 001 This errata provides information applicable to the following products: 1-002-0017 programming adapter Rev.B or earlier These changes allow you to work with secured ARM MCU via JTAG interface STEP1 Remove this resistor STEP2 Prepare the four wires. About 5cm in length. 1A 2A 3A 4A 1B 2B 3B 4B 1A 3A 2A 4A STEP3 Solder wire shown in the corresponding points at the bottom side 2B 3B 4B 1B STEP4 Solder wire shown in the corresponding points at the top side © 2009 TMT www.uobd2.com E-Mail:[email protected] MSN:[email protected] Tel:0086-13986168065 SKYPE:greebid6 www.uobd2.com www.uobd2.com

Transcript of ...INTRODUCTION XPROG-m Errata Sheet 001 This errata provides information applicable to the...

Page 1: ...INTRODUCTION XPROG-m Errata Sheet 001 This errata provides information applicable to the following products: 1-002-0017 programming adapter Rev.B or earlier These changes allow

INTRODUCTIONXPROG-m Errata Sheet 001

This errata provides information applicable to the following products:● 1-002-0017 programming adapter Rev.B or earlier

These changes allow you to work with secured ARM MCU via JTAG interface

STEP1

Remove this resistor

STEP2

● Prepare the four wires. About 5cm in length.

1A

2A

3A

4A

1B

2B

3B

4B

1A

3A

2A 4A

STEP3

● Solder wire shown in the corresponding points at the bottom side

2B

3B

4B1B

STEP4

● Solder wire shown in the corresponding points at the top side

© 2009 TMT

www.uobd2.com

E-Mail:[email protected] MSN:[email protected] Tel:0086-13986168065 SKYPE:greebid6

www.uobd2.com

www.uobd2.com