Post on 03-Aug-2020
Pipo Smart S1 Battery ReplacementUse this guide to change the battery in your Pipo Smart S1 tablet.
Written By: Ali Alqallaf
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 10
INTRODUCTION
The guide will take you through the process of replacing a dead or defective battery in a Pipo SmartS1 tablet.
TOOLS:Phillips #0 Screwdriver (1)Heavy-Duty Spudger (1)Plastic Spudge Plastic Prying Tool (1)Soldering Iron (1)
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 10
Step 1 — Battery
Insert a blue plastic spudger in themiddle of the two bodies of yourPipo S1 at the bottom of the devicewhere the charging port is.
Step 2
Use the same Spudger and slide it along the gap you are creating , moving to the right directionagainst the mini usb port.
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 10
Step 3
Gently pry the body of the Pipo andpop the back cover open. Lift theback cover of the device and place iton the side.
Step 4
Lift the edge of the white tape withthe plastic opening tool.
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 10
Step 5
Lift the white tape with your fingers and then lift the yellow tape holding the extension of thebattery.
Step 6
On the bottom of your tablet, takeyour J000 screwdriver and take outthe two 3mm screws out.
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 10
Step 7
Focus on the Headphone Jack as we will work on it. Lift it and move to the other side placing it onthe surface you are working on.
Step 8
Pry the battery using the Spudger to detach it from the glue underneath it.
Be careful not to pinch the battery (Lithium batteries are great hazard and are prone to short circuitand thus burning or/and exploding.
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 10
Step 9
Lift the battery and place it a littlefurther from the positive andnegative battery wires.
Step 10
Using your soldering iron, melt thetwo lead spots to detach the wires.
the soldering iron is extremely hot,handle with caution. Always keepthe soldering iron holder next to youwhen using it so you can return itback on the holder.
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 10
Step 11
Remove the two wires. Then remove the battery completely from the device.
Beware to tape the negative and positive battery wires to keep them from short-circuiting.
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 8 of 10
Step 12
Place your new battery in the tablet.
Soldier the positive and negative battery wires to the board.
Beware to soldier the right pole to the right spot on the circuit board as swapping them can burnthe motherboard.
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 9 of 10
To reassemble your device, follow these instructions in reverse order.
Step 13
Reinstall the holding down tape and make sure everything is back in place.
Step 14
Attach the back cover and press on it until it clicks.
Pipo Smart S1 Battery Replacement Draft: 2019-04-05Guide ID: 73110 -
This document was generated on 2019-09-21 06:42:05 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 10 of 10