Post on 07-Aug-2018
8/20/2019 Wired Liquid Level Acquistion
http://slidepdf.com/reader/full/wired-liquid-level-acquistion 1/1
Click on “Pick a Sensor” buon
The background no
screen will show. C
“Take Shot”.
Report can be
printed or
emailed
Click on “Report” buon
Sensors are automacally se-
lected based on prior setup.
Click “pick a sensor” if you want
to change sensors.
Well Analyzer Gas Gun & PT
Use methods and tools
to refine results
View Pressure
Buildup
1
Click on “Pick Well” buon
Connect Well Analyzer 2 Select Liquid Level
Click on “Liquid Level”
buon
3 Pick Sensors 4 Zero the Pressure Sensor
5 Install Sensors on Well 6 Start AcquisitionClick on
“Start New
Test” buo
8 Get Report
7 Results, Finish Pressure Buildup
If using a PT, observe casing pres-
sure buildup
for
one
to two
mins,
then click “End Pressure Buildup”
to stop test.
Click the “Zero Off set” tab,
then click “Get New Off set”
When finished, close popup window to proceed with
tesng. Changes save automacally.
Click the “Use Shown Value
to accept new off set
Wired Liquid Level AcquisitionWired Liquid Level AcquisitionWired Liquid Level Acquisition
Charge the gas gun 150-300 psi
above surface pressure on the well.
Close the gun bleed valve.
Open casing valve between gun
and wellhead.
Close casing valve to the flowline.
QAD 5000-6