Post on 17-Jan-2016
Weekly Checks
• Monday – VSP Room
•Tuesday – Pilothouse System Controls
• Wednesday – Starboard / Engine Room
•Thursday – Foam Room
• Friday – Port / Engine Room
Monday – VSP Roomweekly checks
Visually Check:• Hvac system for leaks & valve settings• Fresh water system for leaks & valve
settings• VSP linkage • Autopilot connections• Ventilation fan switch and breaker• Fuel Valves at the fwd tank for leaks &
settings• Fuel valves at the transfer pipe for leaks &
settings
Monday – VSP RoomWeekly Checks
•Cycle all valves in the VSP room•Check oil level in the VSP units•Check oil level in the VSP header tanks•Check bilge for water and pump or suction as needed•Check fresh water system for leaks•Check hot water heater for heat•Fill day tanks and check and record fuel level in the fwd fuel storage tank• Pump out grey water tank as needed•Check hydraulic oil storage tank level – fill as needed•Check and replace lights•Check ventilation fan plenum for water – drain as needed•Check general alarm bell & light•Check phone & intercom # 107•Clean / wipe / wash / service all areas as needed
Monday - VSP Room
Pump out grey water tank
Cycle the overboard valve located on the starboard side
Pump switch
50 gal. tank
Overboard valve
Monday – VSP Room
• Fill day tanks• Stick and measure
main storage tank• Measure sight
gauge for the fwd storage tank
• Record fuel onboard
Between each colored mark is 1000 gallons
Monday – VSP Roomweekly checks
• Cycle VSP cooling overboard valves P&S
• Cycle HVAC overboard valve starboard side
• Cycle grey water overboard valve starboard side
Port Side
VSP cooling
Monday – VSP Roomweekly checks
HVAC overboard
Grey water overboard
VSP cooling
Starboard Side
Monday – VSP Roomweekly checks
Check VSP unit oil level P & S
Dipstick location
Replace gently to avoid cross threading
Operating range
Look for signs of water (foam/milk)
Monday – VSP Roomweekly checks
Tank Fill
Sight gauge
Refill at this Level
Discharge – Oil out
Monday – VSP Roomweekly checks
• Remove / Lift floor plate and check for water
• NEVER PUMP OILY NEVER PUMP OILY WATER OVERBOARDWATER OVERBOARD
• Start pump and listen Start pump and listen for prime – NEVER run for prime – NEVER run dry – use prime valves dry – use prime valves if necessaryif necessary
• Close all valves when Close all valves when finishedfinished
Check under this floor plate
On / Off
VSP Room Valve
Prime valves
Bilge suction under floor plate
Tuesday – pilothouseweekly checks
• Cycle all valves forward & aft
• Operate all Monitors forward & aft
• Check all indicator lights
• Cycle below deck cameras
• If needed, reset camera angles below deck
• Operate remote monitor controls from main deck
Tuesday – pilothouseweekly checks
Monitor controlsValve & pump controls
Engine and throttle controls
Tuesday – pilothouseweekly checks
Camera control boxesCamera Monitor
Tuesday – pilothouseweekly checks
Remote aft deck / boat deck monitor controls
• Boat Deck• Aft Deck
Wednesday – starboard side engine roomweekly checks
•Cycle all valves on the starboard side of the engine room•Check all systems, connections, valves, & bilges for leaks•Wipe / wash / vacuum / polish / service all areas as needed•Check and replace lights as needed•Check phone / intercom & # 106•Check general alarm (bell & Light)•Check oil level in the fire pump hydraulic clutches – Main Engine & Pump Engine
Wednesday – starboard side engine room
weekly checks
• Fresh water flush valve
• Raw water seachest valve
• Raw water isolation valves
Wednesday – starboard side engine room
weekly checks
Raw water inlet valve – Pump Engine
Fire pump sea chest inlet valve
Sea chest valve “wheel”
Wednesday – starboard engine roomweekly checks
Main engine raw water overboard
Generator raw water overboard
Wednesday – starboard engine roomweekly checks
Pump Engine Raw Water Overboard
Wednesday – starboard engine roomweekly checks
Firemain by-pass valve (pump 3)
Firemain by-pass valve (pump1)
Hydraulic Clutch (pump #3)
Wednesday – starboard engine roomweekly checks
Hydraulic clutch (pump #3) Hydraulic clutch (pump #1)Remove guard for service
Oil level dipstick – check while NOTNOT engaged
Wednesday – starboard engine roomweekly checks
Sea chest Valve Pump #5
Fuel Fill Valve
Wednesday – starboard engine roomweekly checks
Sea chest vent / blow down valve
Foam delivery valve
Wednesday – starboard side
weekly checks
Fire main by-pass valves
Pump #5Pump #6
Thursday – foam roomweekly checks
• Cycle overboard valves•Visually check all hydraulic HPU connections for leaks•Check bilge for water – Pump as needed•Check lights and replace as needed•Wipe, clean, paint, vacuum, service area as needed
Thursday – foam roomweekly checks
Firemain “Overboard” valve
Foam storage & foam pump inlet valves
Thursday – foam roomweekly checks
Hydraulic Power Units “HPU’s”
Under wharf Monitors
Aft Capstan
Thursday – foam roomweekly checks
Hydraulic Power Unit for the Deck Crane
Friday – port side engine roomweekly checks
• Cycle all valves on the port side of the engine room• Check all systems, connections, valves, & bilges for leaks• Wipe, wash, vacuum, polish, service all areas as needed• Check and replace lights as needed• Check oil level in the fire pump hydraulic clutches – main
engine & pump engine
Friday – port side engine roomweekly checks
Bilge pump overboard valve
Main engine raw water overboard valve
Friday – port side engine roomweekly checks
Raw water sea chest valve
Cooling system fresh water flush valve
Friday – port side engine roomweekly checks
Hydraulic clutch – pump #2
Remove guard for service
Hydraulic clutch – pump #4
Hydraulic oil level dipstick
Friday – port side engine roomweekly checks
Generator raw water overboard
Pump engine raw water overboard
Friday – port side engine roomweekly checks
Air Dryers Compressor oil level dipstick
Friday – port side engine roomweekly checks
Sea chest valve pump #6
Sea chest valve for pump #2Raw water inlet valve
Friday – port side engine roomweekly checks
Firemain by-pass valves
Pump #2Pump #4
Friday – port side engine roomweekly checks
Bilge Pump System Manifold
Fire pump & firemain drains