Post on 31-Dec-2015
description
Teflon Insulating
Sleeve
6” lengthoutside
of the coilshell
A
A
View
A-A
Thru hole in coil shell
Coil Shell
Winding Pack
Tube bending block(G-10)
Tube groovesmachined in block
Perhaps a strip of rubber may need to be glued to the bottom of the block tokeep it from sliding while
bending the tube over
The other half of the bendingblock can be used to supportand hand form the tubing over the lower block
Bend the tube over and back up
Protective Cover Bracket
(.125” thick SSt)
Spot Weld.25” Dia. hole
1.5”
1.5”
1.5”
A
A
.5”
“Great Stuff”(or equivalent)
Slip on a protectiveplastic end cap
Teflon sleeve is peeledback for coupling brazing
at coil assembly