Post on 15-May-2018
1
Ishik university
Engineering department
Civil engineering
Summer School “Simulation and Modeling of
technical processes”
Prepared by: Yousif Mahmood & Razhan Shahab
Stage: 4th Grade
Location: Germany/Freiberg
Starting date of summer school: 18/9/2017
Ending date of summer school: 29/9/2017
2
Introduction: -
The summer school was held within the scope of the Mechanical
Engineering Germany –Iraq (MEGI) project at the TU Bergakademie Freiberg
(MEGI is part of the German – Iraq Academic Partnership program of the German
academic exchange service (DAAD), and it was supervised by Dr. Abdulkader
Kadauw MEGI project coordinator. the summer school was to improve the
students’ knowledge in modeling basics.
Schedule of the summer school: -
First day: Introduction to MEGI and summer school by Dr.-Ing. Bertram
Hentschel, Ms. Manuela Junghans, and Dr.-Ing. Abdulkader Kadauw.
Second day: Lectures of planning experiments and Metal cutting
modeling and simulation by prof. DR.-Ing. Jurgen Bast, TU BAF and Dr.
Mohanned Al-Khafaji, UoT Bagdad.
Lab visits to Geotechnical engineering laboratory and 3D laboratory by
Prof. Dr.-Ing. Habil. Nandor Tamaskovics and DR.-Ing. Abdulkader
Kadauw.
Third day: lecture of fuzzy set theory and fuzzy logic by
Dr.abduljabbar,Uos Erbil and visiting to a wind turbine of halite
company including several meters of climbing inside the tower,
depending on weather condition (wind speed less than 7 m/s)
supervised by Dr-ing abdulkader kadauw & Dr.Mohammed Al-Fahaam.
Barbecue night.
3
Fourth day: visiting and teaching mine,,Reiche Zeche,, supervised by
Dr.Mohammed Al-Fahaam & MSc.Abdulamer Dheya lectures of
Building strain measuring Device based on Arduino microcontroller By
Dr.Mohammed Al-Khafaji,UoT Bagdad & lecture of Evaluation of the
residual stresses in advanced manufacting process using design of
experiment & finite element By Dr.Adel Mahmoud, diyala University
Fifth day: Training CAD-system /NX (NX 10 program) By Dr.-ing Thomas
Geipel
Sixth Day: Terra mineral collection
Seventh Day: Trip to Fortress Konigstein
Eight day: bowling supervised by: Dr.Mohammed Al-fahaam
Ninth Day: Training CAD-system /NX (NX 10 program) By Dr.-ing
Thomas Geipel.
Tenth Day: lecture of simulation in petroleum engineering & petroleum
engineering laboratory By Prof.Dr.M.Amro & MSc.Sarko Hakim
And visiting university library.
11thday: CNC lab and casting lab by, Mr.Hermann and Dr.Mohammed
Al-fahaam and MSc.Abdulamer Dheya
12th day: Evaluation and final meeting