Submitting a File to TK20

Click on the “Courses” tab at the top.

Click on the course you want to open.

Click on the Artifacts tab at the top.

Go to the left column shaded in blue. (Ignore the items under My Artifacts) click on “Create” under

the Artifacts heading.

Click “Please Select”

Then select File

Give the file a title and a description.

Click on the Documents Tab

BE AWARE AT THIS POINT DO NOT

CLICK ON SAVEYOU ARE JUST SAVING A TITLE WHEN YOU DO THIS

Click on “add new”

Click on Browse

On your hard drive or jumpdrive locate the file you

want to send. Attach it.

Give the file a title

Click on the Upload Tab

A File Upload Status Box will pop up as your file is being

uploadedAfter the upload is complete

the box will automatically close

You should see the title of the artifact you have created.

If two files (artifacts) are required for the assignment….Click on the “Add New” Tab again

You will need to go through the same steps again to add

another file.

Click on Browse

On your hard drive or jumpdrive locate the other file you want to send. Attach it.

Give the file a title

Click on the Upload tab

You should see the title of the artifacts you have created.

Place a check mark in the box beside each file and click “SAVE.”

NOW….You are not DONE!Click on the “Courses” Tab.

Find the Course Link in Blue and Click it

Click on the “Activities” Tab

Find the Assignment Link in Blue

Click on the correct assignment link

Click on the “Attach Artifacts” Tab.

Click on the “Add New” Tab

Click “Please Select”

Then Select File

You should see your file with the assigned title

Place a check mark beside your artifact (file) and click on Add at the bottom of the page. (both files will show up)

Place a check mark beside your file and click on Submit

You should see a box beside the Assignment with the Flag down (gone)

Click Close and log out. Congratulations you have submitted your assignment.