Post on 14-Dec-2015
Statewide Traffic Engineers Meeting
Rumble Strip(e)
June 16, 2011Simone ArdoinAssistant Road Design Engineer Administrator
Terminology
• Rumble Strip
• Rumble Stripe
Centerline Shoulder Edge line
Existing Policy
• 12/1997 – Shoulder Rumble Strips to be placed on all 4 lane divided highways with paved shoulders
Centerline Rumble Strip(e)
• Prior to the 2010 Interim Policy, use was limited to abnormal crash locations
Interim Policy
• 08/2010 – Centerline Rumble Strips – 2 lane rural roadways– ≥ 11’ Lanes– 55 m.p.h. speed limit– Asphalt pavement age ≤ 10 years– 6” wide, ½” deep, 7” long on 12” centers
District Wide ProjectsCenterline Rumble Strips
• All 9 Districts• 2159 centerline miles• $14.3 million• Bid between May 2010 and March 2011
Proposed Rumble Policy
• Committee of Safety, Traffic, and Design Engineers from DOTD and FHWA
• Rumble use limited to speeds ≥ 45 mph• Consideration of land usage is important,
especially when placing rumbles in urbanized areas
Centerline - Two Lane Undivided
• Paved surface >24’, use 16” wide rumble (encompasses stripes)
• Paved surface >20’ and ≤24’, use 6” or 7” rumble (fits between stripes)(width to be determined)
• Paved surface ≤ 20’, use 6” or 7” only when crash history warrants
Centerline - Multi Lane Undivided
• Use 12” wide rumble (fits between stripes)
Shoulder/Edge Rumble - Two Lane Undivided
• Paved Shoulder Width ≥ 2’, use 16” wide rumble stripe. (approximately 6” of rumble is in lane and 10” on shoulder)
• Paved Shoulder Width ≥ 1’ and < 2’, use 6”-7” rumble stripe
• Paved shoulder width 0’ to < 1’, use 4” rumble stripe
• Paved surface ≤ 20’, no rumble is to be used
Shoulder/Edge Rumble – Divided Highways
• Same as Two Lane Undivided for both inside and outside shoulders
ADDITIONAL NOTES• Based on above criteria, shoulder ≥ 5’ would accommodate the 4’ area
needed behind the rumble for cyclists.• If the shoulder is between 2’ and 5’ and the route is determined to be on the
suitability map or future goal map for cyclists, the narrower 6”-7” rumble stripe is to be used. The narrower width rumble stripe would maintain sufficient area for cyclists on an existing 4’ shoulder and would also provide some refuge on shoulders < 4’ in width.
• Gaps in the shoulder rumbles are to be spaced at regular intervals and utilized on all routes, with the exception of Interstate routes, in consideration of any current or future cyclists.
• If shoulder widths vary between two ranges, use the rumble width for the average shoulder width.
• Raised Pavement Markers may be used in lieu of ground or formed rumbles. • Terminate centerline and shoulder rumbles at guard rail and/or bridge
locations.• CMF for centerline rumble on a 2 lane undivided highway = 0.94
FURTHER DISCUSSION
• Transverse Rumbles • Define Gap lengths for cyclists, intersecting
streets and major driveways • Future Research – Ground in Rumble Strips –
detriment to pavement structure?
District 04 ProjectShowing Stripe
District 04 Project
Problems Encountered
Centerline Rumble StripLA 1019
First Project Completed in LA
THANK YOU
Special Thanks to:Traffic Engineering Management SectionHighway Safety SectionRoad Design SectionDistrict 62FHWA