Post on 31-May-2022
STANDARD EMBOSSING FOLDERS
Platform D
Platform C
Platform ATip: For best results, experiment with scrap
Tip: Use both sides of the platforms to prevent warping.
Embossing Folder+ Material
Remove the combinationonce the motor stops running.
Release when the rollers beginpulling the platform combination
into the machine.
Keeping the platform combinationstraight, guide into the eBosser
with steady forward motion.
Position material inside theembossing folder.
Position the embossing folderbetween platforms ‘A’ & ‘C’.
Stack the combinationonto platform ‘D’.
Platform D
Platform C
Platform A
tMa erial
Shim
Cutting Die
Platform D
Platform C
Platform B
Platform A
Rubber Mat
tMa erial
Cutting Die
USING OTHER BRANDS
Cuttlebug/Ellison SizzlitsCutting Dies
Thin Metal Embossing Dies*
*Up To 0.85mm Dies*Shim E & the Magnetic Shim Are Interchangable
Platform B
Platform D
Platform C
Platform A
Material
Cutting Die
Spellbinders/Cheery Lynn/Lifestyle Crafts/Stampin’ Up!Thin Metal Cutting Dies
*Shim E & the Magnetic Shim Are Interchangable
Platform A
Stampin’ Up! Sizzix Dies
tMa erial
Platform C
Cutting Die
Cutting Die
Platform C
Platform A
Material
USING OTHER BRANDS
SizzixCutting Dies
AccuCut Go Dies
AccuCut Wood Dies*Does Not Require Base Platforms
Cutting Die
Platform D
Platform
A
Material
Cutting Die
Platform
A
Platform A
Material
Platform A
Cutting Die
Platform C
SizzixMovers & Shapers
Platform D
Embossing Plate
Magnetic Shimor Shim E
Material
Rubber Mat
Platform B
Platform C
Fiskar Fuse Embossing Plate*(removed from cutting tray)
*If the embossing is too pronounced, you may remove Shim E/Magnetic Shim to soften the embossing. *Shim E & the Magnetic Shim Are Interchangable
USING OTHER BRANDS
Fiskars Fuse
IMPORTANT:Please adhere to the combination charts provided for each brand.If you do not see a certain brand listed, please contact Craftwell
Customer Support for further information.Email: support@craftwellusa.com Phone: 888-315-8885
Inserting the incorrect platform combination may damage your machine and void your warranty.
Cutting Dies
Platform A
Platform A
Platform A
Platform A
Material
Cutting Die
Spellbinders M-BossibilitiesEmbossing Folders
*Shim E & the Magnetic Shim Are Interchangable
Platform D
Platform C
Shim
Platform B
Embossing Folder+ Material
Lifestyle Crafts Letterpress
Platform A
Platform A
Platform A
LifestyleLetterpress