Sony PlayStation SCPH-9002 TeardownWritten By: imacg517

Sony PlayStation SCPH-9002 Teardown Draft: 2019-11-14Guide ID: 2631 -

This document was generated on 2019-11-17 02:17:03 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7

INTRODUCTION

I have a PlayStation 1, and i have decided to make a new teardown of it.

I'm spanish, so my english is a bit poor, and sorry for the mistakes made in this teardown.

Without further delay, we start.

TOOLS:iFixit Opening Tools (1)Spudger (1)64 Bit Driver Kit (1)

Sony PlayStation SCPH-9002 Teardown Draft: 2019-11-14Guide ID: 2631 -

This document was generated on 2019-11-17 02:17:03 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7

Step 1 — Sony PlayStation SCPH-9002 Teardown

Here's the PS1.

Turn the PS1 over and remove the six screws.

Step 2

Remove the top cover. It's veryeasy.

Sony PlayStation SCPH-9002 Teardown Draft: 2019-11-14Guide ID: 2631 -

This document was generated on 2019-11-17 02:17:03 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7

Step 3

Disconnect both CD-ROMconnectors.

CD connector one and the socketit connects to.

CD connector two and the socketit connects to.

Step 4

Remove the CD-ROM reader. You should be able to pull it out gently, although you may have towiggle it around a bit to loosen the rubber holders.

Sony PlayStation SCPH-9002 Teardown Draft: 2019-11-14Guide ID: 2631 -

This document was generated on 2019-11-17 02:17:03 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7

Step 5

Detach both cables. They go to thepower supply and to the memorycards and controller connectors.

Step 6

Remove the four screws and themetal cover.

Sony PlayStation SCPH-9002 Teardown Draft: 2019-11-14Guide ID: 2631 -

This document was generated on 2019-11-17 02:17:03 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7

Step 7

Now you have the motherboard!

And the power supply.

Remove the four screws from themotherboard and the power supply.

Step 8

Once the screws are removed,remove the power supply.

Sony PlayStation SCPH-9002 Teardown Draft: 2019-11-14Guide ID: 2631 -

This document was generated on 2019-11-17 02:17:03 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7

Step 9

Remove the motherboard, and bothof the screws from the memory card/controller connection mechanism.

Step 10

Now, you have all your PlayStation1 parts!

Main Board

Lower Casing

EMI Shield

Power Supply

Disk Reader

Memory Card/ ControllerMechanism

Sony PlayStation SCPH-9002 Teardown Draft: 2019-11-14Guide ID: 2631 -

This document was generated on 2019-11-17 02:17:03 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7