http://start.redrockmicro.comTutorials, forums, customer support

ultraCage DSLR Set-up GuideREDROCK MICRO

Title: Scene:

Company: Pages: of

Date:

1

04.01.12

1

create the cinema experience

5D/7D, D800, SC3 Shoe Clamp Guide

5D/7D & SC3 SHOE CLAMPINSTRUCTIONS

D800 SHOE CLAMPINSTRUCTIONS

INCORRECT(Not �ush with shoe mount)

(Not �ush with top of cage) (Flush with top of cage)

(Flush with shoe mount)

INCORRECT

CORRECT

CORRECT

A

A

B

B

D

D

C

C

E

INSTALLATIONC: Insert Shoe Clamp Spacer CORRECTLY as shown. D: Tighten 1/4”-20 x 7/8” screw from top of cage into

Spacer.E: Insert Thumbwheel/Shoe securely in spacer and

camera shoe mount. Tighten Thumbwheel until camera is secure. Avoid overtightening.

INSTALLATIONC: When height is correctly adjusted, tighten front

screws so Shoe Clamp is secured to camera.D: Slide camera into place. Tighten camera screw from

underneath ultraBase into camera with flat-head screwdriver. Tighten 1/4”-20 x 7/8” screw from top of cage into Shoe Clamp.

SETTING THE HEIGHT*A: With camera secured to cage with camera screw,

insert the Shoe Clamp Spacer BACKWARDS as shown. B: Loosen front screws with hex key. Adjust height of

Spacer so that it is flush with camera shoe mount. *FAILURE TO ADJUST CORRECT HEIGHT MAY CAUSE DAMAGE TO CAMERA.

SETTING THE HEIGHT*A: Remove front screws and disassemble Shoe Clamp.

Tighten screw to secure Shoe to camera as shown. Once tight, reassemble Shoe Clamp.

B: With front screws loosened, adjust height of Spacer so that it is flush with top of cage when camera is in place. This may take some trial and error. *FAILURE TO ADJUST CORRECT HEIGHT MAY CAUSE DAMAGE TO CAMERA.