HOW TO CONFIGURE THE NEW REPEATER:

How to know the repeater is 2G or 3G?

If the product number for the repeater is

1. (AR6517/01400) is( 2G AND 3G) and 4 channel

The base is 3G and the cover is 2G.

2. (AR6517/01200) is only (2G) and 2 channel.

Both the base and the cover are 2G.

Open the Powerwave OM-online software. Connect OMT cable from your PC to the repeater.

HOW TO CONFIGURE THE NEW REPEATER:

. Then press right click on the port then press connect.

HOW TO CONFIGURE THE NEW REPEATER:

Then double click on the base. A window will open as shown above. Click on Ok. The base is 3G.

HOW TO CONFIGURE THE NEW REPEATER:

Then click on channel. Go to the repeater channel click on 1 ,channel number is 10788(Frequency) is standard and downlink gain db is 80 and uplink gain db is 80. After that press set.

Then click on the network to go to the cover.

HOW TO CONFIGURE THE NEW REPEATER:

Then click on the cover. The cover is 2G.

HOW TO CONFIGURE THE NEW REPEATER:

Then double click on the Cover. Window will open as shown above. Click on Ok. The cover is 2G.

HOW TO CONFIGURE THE NEW REPEATER:

Then click on the radio then on the CSel parameters.

HOW TO CONFIGURE THE NEW REPEATER:

Then you see four channels numbering from 1 to 4.Use the frequencies given by customer.

HOW TO CONFIGURE THE NEW REPEATER:

Click on the base to create the report.

Go to file and then click create report.

HOW TO CONFIGURE THE NEW REPEATER:

Click next.

HOW TO CONFIGURE THE NEW REPEATER:

This is the report for the base.

HOW TO CONFIGURE THE NEW REPEATER:

Click on the cover to create the report.

HOW TO CONFIGURE THE NEW REPEATER:

Go to fill then click create report.

HOW TO CONFIGURE THE NEW REPEATER:

Click next.

This is the report for the cover.

HOW TO CONFIGURE THE NEW REPEATER:

Then save it.

HOW TO CONFIGURE THE NEW REPEATER:

How to know the repeater is 2G or 3G?

If the product number for the repeater is

1. (er517…….400) is 2G and 3G

2. (er517………..200) is only 2G.

BR//Nitish Mahajan