Please understand your entire HWH Operator’s Manual BEFORE operating your Leveling System....

Post on 03-Jan-2016

215 views 0 download

Transcript of Please understand your entire HWH Operator’s Manual BEFORE operating your Leveling System....

Please understand your entire HWH Operator’s Manual BEFORE

operating your Leveling System. Instructions may vary slightly from

coach to coach.

310 SeriesBasic Leveling Procedure

Click HERE if ready to continue…

Read CAUTIONS and PROCEDURES carefully.

Pre - Leveling Procedures

1. Place the Gear Selector in the PARK position.

2. Engage the PARK BRAKE.

3. Turn the Ignition Switch to the OFF position.

4. Block the RV tires securely.

5. Turn the Ignition Switch to the ACC position.

Click HERE if ready to continue…

Click HERE if ready to continue…

The following slides will guide you around your 310 Touch Panel. Learn the Panel Basics while executing a Leveling Simulation.

310 Series Touch Panel Basics

Press the “ON” button the “Power On” light above the button should light.

Click HERE if ready to continue…

This Yellow “Level Low” Indicator Light is one of four. There is one light for each side and end of the

RV.

If the “Not in PARK/BRAKE” light comes on set the Brake. The system will not work until this light is out.

No more than one yellow light should be on at any given time.

The objective to leveling is to have no yellow lights on. To do this press and Hold the “EXTEND” Button (UP

ARROW) located closest to the yellow light.

There are four “EXTEND” buttons indicated by (UP ARROWS) for MANUALLY raising the RV.

Click HERE if ready to continue…

As well as four “RETRACT” buttons indicated by (DOWN ARROWS) for MANUALLY lowering the RV.

Continue to hold the “EXTEND” button closest to the yellow light until the Yellow Light goes out. As both

right side jacks extend red “WARNING” lights for each jack will come on.

Click HERE if ready to continue…

The lights are triggered when the corresponding jack is extended 2 or more inches.

There are four red “WARNING” lights, one for each jack.

After having turned out the Right Side Yellow Light the Front Side Yellow Light has come ON.

Click HERE if ready to continue…

This Light indicates that the FRONT of the RV is low.

As before Press and Hold the “EXTEND” button closest to the Yellow Light.

Click HERE if ready to continue…

While holding the “EXTEND” button the Left Front Jack will continue to extend independently of the Right Front

Jack. The Jack “WARNING” light will come on.

Once the Left Front Jack reaches the ground and equal pressure between the Two Front Jacks is reached they

will raise the Front of the RV as a Pair.

Continue to hold the “EXTEND” Button until the yellow “LEVEL LOW” light goes out.

Once the Front Side Yellow Light has gone out release the button.

Click HERE if ready to continue…

With all of the Yellow “LEVEL LOW” Indicator Lights off the RV is LEVEL.

The Left Rear Jack will need to be extended to the ground in order for the RV to be stable.

Click HERE if ready to continue…

Press and Hold the “EXTEND” button located at the rear of the Coach Symbol.

Click HERE if ready to continue…

While holding the “EXTEND” button the Left Rear Jack will Extend. The Jack “WARNING” Light will

come “ON”.

Once the Left Rear Jack reaches the ground and slightly lifts that corner of the RV release the “EXTEND” button,

the RV is stabilized. Push the “OFF” button.

HWH would like to thank you for your Patronage. Please feel free to explore further information we have provided at www.hwhcorp.com

The Basic 310 Series Leveling Procedure

Is Complete.