Post on 16-Jan-2016
Modeling ProcessModeling Process- Shoe mold -- Shoe mold -
08 OCT 2004
Inustechnology,Inc.
1. Scandata
2. Defeaturing about detail shape
3. Create Basic Solid from Bounding Box
4.Create loft surface - create curve by “fit boundary curve” - project curve to Ref.Plane on bottom - project curve to Ref.Plane on Top
5.Cut by surface
6.Create loft surface on top - create curve by ”interpolate”on top surface - project curve to Ref.Plane on front - project curve to Ref.Plane on rear
7.Create loft surface on middle - create curve by ”interpolate”on middle surface - project curve to Ref.Plane on front - project curve to Ref.Plane on rear
8.Separate solid by surface - duplicate this solid - cut one solid by surface - reverse the normal of surface - cut another one by surface
9.Cut by surface - create untrimmed surface by polygon fitting - extend the surface - apply “cut by surface”
10.Cut by surface - create untrimmed surface by polygon fitting - extend the surface - apply “cut by surface”
11.Cut by surface - create curve by “interpolate”on side - project curve to Ref.Plane on bottom - project curve to Ref.Plane on Top
12.Cut by surface - Select face - add feature region - create surface by picking the feature region - cut by surface
13.Union solids
14.Create small bump - create interpolate curve - project the curve on surface - create circle at the end of the curve - apply sweep surfacing (piping) - close both end of the surface like pipe - create solid - union this solid with previous one
15. Final Result