I WimM· iii Configuration Steps Smart Home Make sure your ...€¦ · APP Guide -User Register Run...

Post on 11-Dec-2020

4 views 0 download

Transcript of I WimM· iii Configuration Steps Smart Home Make sure your ...€¦ · APP Guide -User Register Run...

Smart Home

:.\

Smart Wi-Fi Video Doorbell

Ultra Low Power Consumption

♦ Thanks for purchasing and using our product. Please read this quick start

guide before using, and keep it for future reference.

♦ Menu contents are subject to change without notice in accordance with our

policy of continuous product improvement.

I WimM· iii Please consult below checklist for all the components.

Video Doorbell Bracket User Guide

Screw Pack Batteries(Optional) USB Cable(Optional)

Product Drawing

Front

9 PIR Motion Sensor 0 Microphone

49 Infra red LED x 6 0 Indicator

E) Light Sensor

O 166' HD Camera

0 Push Button

Ci) Speaker

Back

..

" □ □ ..

0 8V~24VAC Power Port

CD> Reset Button

Q> Micro USB Port

Cl& Battery compartment cover

Bracket

Power Supply Solution

• Hardwire Power Source

Notice:

8V~24VAC Bell Transformer (Not included)

Mounting Screw Holes x 4

Hardwire Terminals x 2

Doorbell Mounting Hooks x 4

• Powered By Battery

Rechargeable 18650 Battery

Warning:

• Bell transformer is not included. . Please note the battery electrodes!

• Please operate under the direction Insert the 2 batteries with positive

of the professional. sides upwards .. Inappropriate

battery install can damage device.

Connect Device

Make sure your smartphone is connected to a 2.4GHz Wi-Fi network, so

as to configure the video doorbell (The device does not support 5GHz

Wi-Fi network).

Seach and download the APP 'CloudViewer X' from APP Store or

Google Play. The App is also available by scanning below Q-R

code with your smartphone.

D �

\ 24�Hz/

APP Guide - User Register

Run the APP on your smart phone, and register an NC with your E-mail

ID or your phone number.

8 Tap on "Register" 8 Register your account 9 Create password

Register Set Password

Configuration Steps

Power on your device and reset it to factory default by pushing the reset

button at its back. Configure the device following the in-app instructions

to add new devices to your account.

Turn on CloudViewer X -

... "· [2 ••• • & l

:-:

� Add Device

...... -,.- .::.. Powerthedtvlceon•ndmakesurethe

=-ica���::-hirlgQUOCklyoraprompt

--

-

� -·

- - _,

� - = -

" II

-

-

3 J I 4