Post on 27-May-2018
Full Control over Indoor Units Operation •
On/Off control, Cool, Heat, Fan, Dry mode selection, Set Temperature •
Control, Fan Speed Control, Swing Control (for wall mounted and cassette
indoor units), Filter Reset Sign, Group Operations (All On, All Off)
Outdoor and Indoor Units Monitoring •
Failure Alarms, Set point temperature, Operation status (on/off) Operation •
mode (cool/heat/fan/dry), Fan speed (high/low), Filter sign, Swing
Compatible with Daikin/Sanyo/Toshiba/ Mitsubishi Electronic/Hitatchi air •
conditioning systems
The Vantage HVAC InterfacePoint makes it easy to
integrate HVAC systems in the Vantage InFusion
System.
5 different hardware devices are available: HVAC-ID (for
Daikin), HVAC-IS (for Sanyo), HVAC-IT (for Toshiba),
HVAC-IM (for Mitsubishi Electric), HVAC-IH (for Hitachi)
but only 1 driver in the Vantage software. The HVAC
Interface System gains full control on indoor units and
provides access to the system parameters.
It allows homeowners full control with the Vantage
System keypads, touchscreens, motion sensors, timers
etc. and gives feedback from the actual temperature
and setpoints on the TPT touchscreens.*
It simply connects straight to the air conditioning system
two wire communication lines and a Vantage RS-232
control port.
*Temperature feedback not for the Hitachi Interfaces.
Easy set-up in InFusion Design Center
Product Highlights
HVAC
HVAC InTERFACEPoInT
HVAC InterfacePoint
Specifi cations
Thermostat Dimensions 62mm x 112mm x 30mm
2.45”x4.4”x1.18”
Model HVAC-InterfacePoint: HVAC-ID (for Daikin), HVAC-IS (for Sanyo)
HVAC-IT (for Toshiba), HVAC-IM (for Mitsubishi Electric), HVAC-IH (for Hitachi)
Weight 125g (4.4oz)
Serial Connection DB9 Female
HVAC Connection Line Two screw terminals
Power Input 20-30 Vac (24VAC nominal), 60/50Hz
Power Supply 9VDC 100mA included
Typical Control Accuracy ± 1°F at 68°F / ± 0.5°C at 20°C
LCD Display Information On/Off control
Cool, Heat, Fan, Dry mode selection
Set Temperature Control, Fan Speed Control, Swing Control
Filter Reset Sign, Group Operations
InFusion with feedback on the Vantage touchscreen
QLink control codes
General Specifi cations
System Compatibility
Dimensions, HWD
INSIDE VIEWFRONT VIEW
To Vantage Serial Port
HVAC-IDVANTAGE INTERFACEPOINT FOR DAIKIN
62mm (2.45”)
112mm (4.4”)
To AC SystemTo Power Supply
To Vantage Serial Port
To Power Supply
To AC System
LCDCPU
Vantage emea nv/saBinnendijk 40 | 9130 Beveren | BelgiumT +32 (0) 3 773 31 06 | F +32 (0) 3 773 31 05 www.vantage-emea.com