Post on 27-Mar-2018
Genuine Safety. Outstanding Service.
FORMWORK GENERAL PRODUCT GUIDE
Acrow GASSGeneral Product Information
ImportantThe safe use and application of the Acrow GASS
system must be in accordance with Australian
Standard AS 3610 Formwork for Concrete,
Occupational Health and Safety Regulations,
approved industry codes of practice and relevant
regulatory authority requirements.
Any illustrations in the assembly configurations are
minimum guidelines only.
The combined use of the Acrow GASS system with
equipment from other suppliers may entail performance
problems and therefore requires a design check and/or
verification by AF&S Engineering Department.
Acrow can provide appropriate safe work method
statement for assembly and dismantling of the Acrow
GASS system to suit the specific design and project.
Contact Acrow for such information.
Safety WarningThis warning is to draw the users attention to possible
musculoskeletal disorder as a result of manual
handling during assembly and dismantling of Acrow
GASS components. It is recommended that users
of the Acrow GASS system employ and implement
appropriate procedures and control measures to
eliminate or control any risk of Musculoskeletal
disorder/injury while manually handling Acrow GASS
components. Refer to Code of Practice on manual
handling published by local Workcover Authority or
other approved and recognised guidelines for correct
and appropriate manual handling procedures.
Product FeaturesAcrow GASS Aluminium Shoring System is a lightweight
shoring system that provides a fast, efficient and
versatile falsework structure with the benefit of providing
load capacity up to 140kN. The primary product
attributes of GASS are:
• Provision of load capacity up to 140kN
• Light weight and easy to erect
• The ability to brace at 45 degree angles
• Can provide bay size up to 3 meters on light
commercial applications
• Ideally suited to “table form” applications along with
conventional strike and fix flexibility.
In addition the high strength light weight Acrow GASS
system is easy to erect and dismantle leading to
significant labour savings on site.
1 Photographs/illustrations shown within this brochure are intended as expressing the diversity and possible applications of the product and as such must not be used as assembly instructions.
2 In line with Acrow Formwork & Scaffolding Pty Ltd’s commitment to continuous product development and improvement, the information contained in this brochure may be changed without notice.
3 Every effort has been made to give appropriate guidelines for the use of this product, however, Acrow Formwork & Scaffolding Pty Ltd accepts no responsibility for any loss or damage suffered by any person acting or refraining from action as a result of this information.
Should the users require any further information or guidance, they are encouraged to contact their local Acrow Formwork & Scaffolding Pty Ltd outlet.
GASS is SGB Harsco product distributed by Acrow Formwork & Scaffolding under Acrow GASS.
ACROW GASS Formwork SystemD
iscla
imer
2
Product Description Code No. Mass kg (nom.)
Acrow GASS Outer Legs
The Outer Leg extrusion has eight slots which allows attachment of Bracing Frames in multiple directions. The end plates have interlocking features that eliminates eccentricity. The spring loaded latch at the bottom of the Outer Leg provides means of securing the Inner leg to Outer.
Outer Leg 4670Outer Leg 3580Outer Leg 2490Outer Leg 1400
GHOUT467GHOUT358GHOUT249GHOUT140
22.117.412.78.0
Acrow GASS Extension Legs
Extension Legs allow to extent the height of the legs. Where used the serration’s on the edges of the end plates must match each other.4- M12 x 65 Grade 8.8 bolts and nuts with washers are required for each connection.
Extension Leg 4670Extension Leg 3580Extension Leg 2490Extension Leg 1400Extension Leg 500
GHEXT467GHEXT358GHEXT249GHEXT140GHEXT050
23.618.914.29.55.6
General Product Information
3
Outer Leg Head plate Detail
4-M12x65 Gr. 8.8 bolts andnuts with washers.
Safety Latch
Section AA
Section AA
For joining Outer Legs andExtension Legs, theserration patterns on endplates must mate andinterlock.
ACROW GASS Formwork System
Product Description Code No. Mass kg (nom.)
Acrow GASS Inner Legs (Adjustable Jacks)
Provide adjustment for Outer Leg up to 1314mm. The stem has a removable nut restraint screw to prevent over extension and ensure minimum engagement into the Outer Leg.
Inner leg 1680Inner leg 780
GHINL168GHINL078
10.25.5
Acrow GASS Spanner
Used to release the collar of the Inner Leg. GLLSP001 8.0
Acrow GASS Rocking Head / Base Plate
Caters for slopes of up to 15°.
Rocking Head / Base Plate MKIRocking Head / Base Plate MKII
GHRHBPGHRHBP2
8.38.8
4
4-M12x65 Gr. 8.8 bolts andnuts with washers
To ease stripping of GASS Inner Legs when under load, the GASS Spanner locks around the collar of the Inner Leg and promotes a safe and controller release.
An extension arm can be provided for additional torque but maximum torque applied shall not exceed 1kNm.
Required Torque for a GASS Nut when loaded in compression with 140kN is about 1kNm.
The Torque of 1kNm equates to approx. 100kg being applied to the handle 1 meter from the leg centre or 50 kg being applied 2 metres away from the leg centre (i.e. Spanner used with an scaffold tube).
Do NOT use a hammer to tighten or release GASS collars.
Note: Care should be taken when carrying or operating the GASS Spanner at height. It is strongly recommended that athorough risk assessment be carried out.
Product Description Code No. Mass kg (nom.)
Acrow GASS Bracing Frames
Each Bracing Frame is secured in place with four wedge connections. The wedge system has a visible feature for ease of correct installation identification. The top cord of the Bracing Frame provides guardrailing when Access Platforms are used.
Bracing Frame 3000Bracing Frame 2400Bracing Frame 1800Bracing Frame 1200
GHGTE300GHGTE240GHGTE180GHGTE120
15.813.410.39.4
Acrow GASS Single Guard Rails
Used only to provide guard railing (not to be used for attachment of fall prevention equipment).
Guard Rail 3000Guard Rail 2400Guard Rail 1800Guard Rail 1500Guard Rail 1200
GHSGR30GHSGR24GHSGR18GHSGR15GHSGR12
5.75.04.33.93.6
General Product Information
5
Wedge connections
1) Ensure the wedge is in released position before it is offered to the Outer Leg.
2) The Bracing Frame is offered to the Outer Leg and each wedge is pushed up.
3) The wedge mechanism inserts the locking bolt into the Outer Leg slot.
4) The wedge is turned 90 degrees to engage the bolt in the slot.
5) The wedge is hammered in to lock the bolt in the slot.
ACROW GASS Formwork System
Product Description Code No. Mass kg (nom.)
Acrow GASS Cantilever Frames
Used with Handrail Post to provide access along the edge of the formwork.
Cantilever Frame 1200Cantilever Frame 930
GHCLB120GHCLB093
7.25.7
Acrow GASS Handrail Post
Used with Cantilever Frames to provide guardrailing comprising scaffold tubes.
GHHRP001 5.5
Acrow GASS Access Platforms
Used between Bracing Frames to provide access. Each has locking mechanism to ensure resistance against wind loads.
Access Platform 3000Access Platform 2400Access Platform 1800
GLPLT300GLPLT240GLPLT180
23.019.016.4
Acrow GASS Access Platform Trapdoors
Used to provides an opening for ladders.
Access Platform Trapdoor 3000Access Platform Trapdoor 2400Access Platform Trapdoor 1800
GAPTD300GAPTD240GAPTD180
26.219.915.36
Product Description Code No. Mass kg (nom.)
Acrow GASS Infill Decks
Infill Decks are used to cover gaps between Access Platforms in adjacent bays. They are secured to Outer Legs using Deck Retainers.
Infill Deck 3000Infill Deck 2400Infill Deck 1800Infill Deck 1200
GID300GID240GID180GID120
13.310.57.85.1
Acrow GASS Infill Deck Retainer
Used to secure Infill Decks to Outer Legs.Two are required per Infill Deck.
GIDR 0.3
Acrow GASS Ring Bolt Soldier Clamp
Used to connect Slim-Max Soldiers to legs. Two Clamps are required per leg.
GHHSB001 0.5
Acrow GASS T-Bolt Clamp (head to beam)
Used to connect Aluminium Beams to legs. Two Clamps are required per leg.
GHHBB001 0.4
Acrow GASS Ring Bolt Clamp (head to head)
Used to connect legs end plates together. Four Clamps are required per connection.
GHHRB001 0.3
General Product Information
7
Product Description Code No. Mass kg (nom.)
Acrow GASS Advanced Guardrail
Used as a temporary guardrail. They are clamped to both cords of the Bracing Frames to provide edge protection from level below (not to be used for attachment of fall prevention equipment). Advanced Guardrail 1655Advanced Guardrail 1065
GHAGR165GHAGR106
119.5
Acrow GASS Leg Joining Spigot GLJS 2.1
Acrow GASS Leg Safety Catch GHLSC 0.6
Acrow GASS Leg Bracing Coupler GHLBC001 TBA
Acrow GASS Universal Clamp
Connects secondary beams to primary beams.
GHUC001 0.6
ACROW GASS Formwork System
8
TITAN T-Bolt Clamp
Bracing Coupler Fixed toGASS Leg
Product Description Code No. Mass kg (nom.)
Acrow GASS Universal Anchor Clamp
Used to clamp Aluminium beams to each other or to Slim-Max Soldiers.
GHUAC001 0.3
Acrow GASS Jack Bracing Collar
Used to connect Diagonal Brace to Inner Legs.
GHJBR001 1.5
Acrow GASS Jack Guardrail Collar
Used to attach top chord of Bracing Frame or Single Guard Rail to jacks.
GHGC001 1.1
Acrow GASS Corner Brace
Used to ensure that each corner is erected with thru 90 degrees angles and is square.
GHCB TBA
General Product Information
9
Product Description Code No. Mass kg (nom.)
Acrow GASS Lifting Trolley (Standard)
Used to move assembled units around.
GHLTS001 188
Acrow GASS Lifting Trolley (Low Level)
Similar to Standard type but the trolley can be tipped over into its back.
GHLTLL001 188
Acrow GASS Castor Shoe
They are attached to underside of legs and used to move assembled units around on a level and smooth surface for a short distance.
Caster Shoe 200Caster Shoe 250 GHCS200
GHCS2509.8
12.0
Acrow GASS Castor Wheel GHCWH001 1.5
ACROW GASS Formwork System
101. Strike GASS Leg2. Slide Castor Plate Onto Baseplate3. Engage Bolt Into Slot Of Baseplate
M12 Bolt
11
Product Description Code No. Mass kg (nom.)
Acrow Gass Trolley Unit
Used in conjunction with Trolley Inner to move assembled towers around on a level and smooth surface for a short distance.
Acrow Gass Trolley OuterAcrow Gass Trolley Inner
GHTO001GHTI001
12.515.5
Acrow GASS T225 Aluminium Beam
Used mostly as a primary beam.
T225 Al Beam 1500T225 Al Beam 1600T225 Al Beam 1800T225 Al Beam 2000T225 Al Beam 2100T225 Al Beam 2400T225 Al Beam 2700T225 Al Beam 3000T225 Al Beam 3200T225 Al Beam 3600T225 Al Beam 3700T225 Al Beam 4200T225 Al Beam 4600T225 Al Beam 4800T225 Al Beam 5000T225 Al Beam 5200T225 Al Beam 5400T225 Al Beam 6000T225 Al Beam 6400
GHSAB15GHSAB16GHSAB18GHSAB20GHSAB21GHSAB24GHSAB27GHSAB30GHSAB32GHSAB36GHSAB37GHSAB42GHSAB46GHSAB48GHSAB50GHSAB52GHSAB54GHSAB60GHSAB64
8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m8.9kg/m
General Product Information
11
Trolley Outer Trolley Inner
Acrow Gass Trolley Unit clamps to Bracing Frameswith Half Couplers
Formwork
Scaffolding
Industrial & Mining Scaffolding
Phone: 1300 138 362or contact your business development manager.www.acrow.com.au
Contact
Up
dated
Octob
er 2012