Post on 06-Jul-2018
8/17/2019 Fluid Power - (ME353)- Lec9-A
1/12
Fluid Power Systems (ME353)
Fall 2012
Lecture 9
8/17/2019 Fluid Power - (ME353)- Lec9-A
2/12
Directional ControlDevices
8/17/2019 Fluid Power - (ME353)- Lec9-A
3/12
Directional control devices allow a system operator to control the directionof fluid flow in the system –
Starting and stopping of actuators – Control of actuator movement direction
Directional control devices can be grouped in four general classifications – Shut-off or two-way valves – Check valves – Three-way valves – Four-way valves
Symbols for directional control valves
8/17/2019 Fluid Power - (ME353)- Lec9-A
4/12
The primary purpose of shut-off valves is to block fluid flow through ahydraulic system line – Globe valve
– Gate valve – Ball valve – Spool valve – Needle valve
Typical globe valve
8/17/2019 Fluid Power - (ME353)- Lec9-A
5/12
Typical gate valve
Typical ball valve
8/17/2019 Fluid Power - (ME353)- Lec9-A
6/12
Typical spool valve Typical needle valve
8/17/2019 Fluid Power - (ME353)- Lec9-A
7/12
The primary purpose of check valves is to allow free flow inone direction while preventing reverse flowOther functions include: – Bypassing components during the return cycle of the system – Providing flow resistance to maintain a minimum system
pressure required for pilot operations
Typical inline check valve Typical right-angle check valve
8/17/2019 Fluid Power - (ME353)- Lec9-A
8/12
A standard check valve consists of a valve body containing aone-way valve located between inlet and outlet ports – The one-way valve allows fluid flow through the valve in
only one direction – Some designs contain a spring that seats the valve poppet or
ball – In other designs, the poppet is seated only by fluid flow
8/17/2019 Fluid Power - (ME353)- Lec9-A
9/12
Restriction check valves allow free flow in one direction andrestricted flow when flow direction is reversed
This is accomplished via a metering orifice machined into the poppet
Typical restriction check valve
8/17/2019 Fluid Power - (ME353)- Lec9-A
10/12
Pilot-operated check valves can allow reverse flow throughthe valve
– Typically, pilot pressure opens the valve – In some designs, pilot pressure may also hold the valve shutto block flow in both directions
Pilot pressure to open check valve
Pilot pressure to block flow through valve
8/17/2019 Fluid Power - (ME353)- Lec9-A
11/12
Three-way directional control valves provide a means to extendrams and single-acting cylindersThe actuator is returned to its original position by an external force
– System load – Spring built into the actuator
Typical three-way directional control valve
8/17/2019 Fluid Power - (ME353)- Lec9-A
12/12
During extension, the three-way valve connects the actuator inlet line to asystem supply line, allowing fluid to enter and extend the unitDuring retraction, the valve blocks the supply line and connects the actuator
line to a system return line, allowing external force to return the actuator toits original position while directing displaced fluid to the reservoir