Post on 24-Feb-2016
description
Copyright © 2012 Idondivi, Inc. All rights reserved.
Carrier for 3D Click Guide ; Thermoplastic or VPS
2 Copyright © 2012 Idondivi, Inc. All rights reserved
TAK thermoplastic granules or sticks soften in hot water ( 160 F) stay moldable
for 5-10 minutes and are tough plastic once cooled.
3 Copyright © 2012 Idondivi, Inc. All rights reserved
Case of two implants together WD & ND
4 Copyright © 2012 Idondivi, Inc. All rights reserved
1 scoop of granules in hot water, white hard turns into clear moldable
5 Copyright © 2012 Idondivi, Inc. All rights reserved
Plastic mass moldable with 1 % shrinkage
6 Copyright © 2012 Idondivi, Inc. All rights reserved
Place soft mass onto teeth
7 Copyright © 2012 Idondivi, Inc. All rights reserved
Place BLP in correct position, relative to the teeth and the estimate root position
8 Copyright © 2012 Idondivi, Inc. All rights reserved
Repeat for the other implant
9 Copyright © 2012 Idondivi, Inc. All rights reserved
Adjust so the mesio-distal position is exactly as desired relative to the visible
tooth structures, and the estimated rootmorphology
10 Copyright © 2012 Idondivi, Inc. All rights reserved
Add material as needed. The softened material stays pliable for 5- 10 minutes
11 Copyright © 2012 Idondivi, Inc. All rights reserved
Reinforce as desired
12 Copyright © 2012 Idondivi, Inc. All rights reserved
Thermoplastic material will harden in 1 hour at room temperature or 5 minutes in
cold water
13 Copyright © 2012 Idondivi, Inc. All rights reserved
Material can be adjusted, while appreciating the thermoplastic nature
14 Copyright © 2012 Idondivi, Inc. All rights reserved
Vacuform vs thermoplastic, same case different materials, all work, you pick
Copyright © 2012 Idondivi, Inc. All rights reserved.
Carrier for 3D Click Guide ; VPS
16 Copyright © 2012 Idondivi, Inc. All rights reserved
VPS ; stiff bite registration material
17 Copyright © 2012 Idondivi, Inc. All rights reserved
Blu-Mouse from Parkell is radio-opaque