Post on 17-Aug-2021
Designed by Steve GoodDigital Patterns
Hundreds of free PatternsStencil PrinterJigsaw Puzzle TemplatesDVD’sKey Chain Pattern PrinterVideo TutorialsReviewsCommunity Forum and more.
If you would liketo donate click
here. No Paypalaccount needed.
Note to commercial print employees: I give my permission to print as many of this pattern book as your customer requires.
steve@stevedgood.com Copyright Steve Good 2017
Note to commercial print employees: I give my permission to print as many of this pattern book as your customer requires.
steve@stevedgood.com Copyright Steve Good 2018
General Pattern InformationYou may use this pattern to make as many of the project as you like. You are free to use any technique including mass production to build the project. The pattern may be copied and
given to others provided the entire book is kept intact. You may not sell the pattern or include it
in another commercial package of any type.
Steve Good retains the right to the pattern. If you have any questions about the use of this
pattern please contact me at steve@stevedgood.com
Printing InstructionsWhen printing this pattern it is important to print it full size. When you bring up the print dialog
box look in the “Page Sizing & Handling” section. Make sure the “Actual Size” is selected
before you hit print.
You also only need to print the page/s you need. After the print dialog opens look for the
“Pages to Print” section. You can print the current page or a range of pages. This will help
save ink by not printing the title/instruction pages.
Circus Wagon
Important:Assembly instructions are in a video at the following link.You will likely have trouble if you do not watch the video.
https://youtu.be/sQWkwSwFNZg
2
2
2
Horse Assembly Guide
All parts are cut from 1/8” thick Baltic Birch Plywood.
1
2
2
2 1
Front and back
Center
Seat.
Seat assembly guideside view.
2
2
6
42
For middle wagon only.
Spacer
17/64” Hole
1/4” Holes
Wagon c
onnect
or
pin
Cut dow
el 1
” lo
ng
3
17/64” Hole 17/64” Hole
The axels are 1/4” diameter dowels. Cut them 5” long.
Dowel rods can vary in thickness. Test fit the dowelsin the axle holes and wheels before drilling final holes.
4
3 3
Wagon Top and Bottom
Wagon Front. Wagon Back
6
Only cut this in one topfor giraffe head to stick out.
5
12
Stack cutthree of this set of wheels
The center holeis drilled to1/4” diameter.
6
2 2
2
ends front/back
top/bottomstrap
latch
22
22
2
Monke
y B
ars
Monke
y B
ars
Chest
2
2
7
2
2
Bear for Wagon one
There are two lions in wagon two
8
The giraffe goes in wagon three.
9
2 2
2
2
2
2
2
Front
Back
BT Stand for Big TopCircus.
10
2
2
11
Elephant Assembly Diagram
Note that there is a front and back side blanket.
Elephant Base Cut 2
12