Designed by Steve GoodDigital Patterns

Hundreds of free PatternsStencil PrinterJigsaw Puzzle TemplatesDVD’sKey Chain Pattern PrinterVideo TutorialsReviewsCommunity Forum and more.

If you would liketo donate click

here. No Paypalaccount needed.

Note to commercial print employees: I give my permission to print as many of this pattern book as your customer requires.

steve@stevedgood.com Copyright Steve Good 2017

Note to commercial print employees: I give my permission to print as many of this pattern book as your customer requires.

steve@stevedgood.com Copyright Steve Good 2019

General Pattern InformationYou may use this pattern to make as many of the project as you like. You are free to use any technique including mass production to build the project. The pattern may be copied and

given to others provided the entire book is kept intact. You may not sell the pattern or include it

in another commercial package of any type.

Steve Good retains the right to the pattern. If you have any questions about the use of this

pattern please contact me at steve@stevedgood.com

Printing InstructionsWhen printing this pattern it is important to print it full size. When you bring up the print dialog

box look in the “Page Sizing & Handling” section. Make sure the “Actual Size” is selected

before you hit print.

You also only need to print the page/s you need. After the print dialog opens look for the

“Pages to Print” section. You can print the current page or a range of pages. This will help

save ink by not printing the title/instruction pages.

Model Sail Boat

One inch dowel cut on an angle.

I used 1/8” dowel here and sandedit flat on one side. You can just cutflat stock if that is what you gave.

The hull of the boat is layered 1/4” thick Baltic birchplywood. It is then contoured by sanding into the shape

of a boat hull.

I used CA glue and spray activator to assemblethis model. It is much easier than trying

to clamp these pieces together while wood glue dries.

To build the front rail I cut 1/8” dowel with an Exactoknife and CA glued the rail together.

I also used 1/8” dowel for the mast pieces. Thedowel was sanded flat on one side and CA glued

to the sails.

If you do not have 1/8” dowel just cut the flat stockfor the mast and round over the edges.

1/4” Thick

2

1/4” Thick 1/4” Thick

1/8” ThickCut

1/4” Thick 1/4” Thick

2

1/4” Thick

Cut

Mast hole

Cabin Top CabinBottom

CabinWindows

Mast Retainer

1/8” Thick

2

1/8” Thick

Life Preservers.

1/8” Thick

Cut 2

Cut 2

Mast

One on each side of the sails.

One o

n e

ach

sid

e o

f th

e s

ails

.

1/4” Thick1/4” ThickBase

Base

Dowel