D1: Virtual desktop

By Samuel coghlan-white

Power supply unit

• To add the power supply slot it in place and secure with screws

• Connect the power supply to the motherboard, hard drive and disk drive

RAM

• Place the RAM in the allotted slot and then clip then in

CPU

• Place the prosser in the correct position • Fold the clip down then the pin • Then place thermal compound on the CPU

Heat sink

• Place the heat sink on top of the prosser • Screw in place then connect it to the

motherboard

motherboard

• Place the motherboard in the right place then screw it in

Adapter cards

• Place the card in the right bus slot and then screw in place

Hard Drive

• Insert the hard drive then screw in place with screws

• Connect it to the mother bored with the SATA cable

Disk Drive

• Place the disk drive in the external bay then screw in place

• Connect the disc drive to the motherboard with a PATA cable

Monitor

• Connect the VGA cable to the computer and then the monitor

Other peripherals

Keyboard/mouse:• Plug the mouse/keyboard into the back of the

tower

• screw the antenna into the network card at the back