Post on 07-Apr-2018
8/6/2019 6 Amplitude Modulation
1/15
6 - A M PL I T UD E M O D UL AT IO N
B A S I C P R I N C I P L E S
PRINCIPLES OFCOMMUNICATIONS
8/6/2019 6 Amplitude Modulation
2/15
AMPLITUDE MODULATION
Amplitude Modulation Amplitude modulation is defined as a system of modulation in which the amplitude of the carrier is made proportional to theinstantaneous amplitude of the modulating voltage.
8/6/2019 6 Amplitude Modulation
3/15
AM WAVE
Amplitude modulated wave and equation:
8/6/2019 6 Amplitude Modulation
4/15
AM PARAMETERS
Modulating Index and PercentModulation
The modulating index shouldnot exceed 1 (100% for thepercent modulation)
Greater than 1 modulating index will cause over-modulation ordistortion in the modulated waveform, which may affect theintelligence of the signal.
Assignment: What is adjacent channel interference due to over-modulation? How can over-modulation be prevented? (Explain indetail)
8/6/2019 6 Amplitude Modulation
5/15
SIDE BAND AND BANDWIDTH CALCULATIONS
AM signal:
Upper Sideband:
Lower Sideband:
Bandwidth Requirement:
8/6/2019 6 Amplitude Modulation
6/15
AM WAVEFORMS AND SPECTRUM
8/6/2019 6 Amplitude Modulation
7/15
TIME DOMAIN AND FREQUENCY DOMAIN WAVEFORMS
8/6/2019 6 Amplitude Modulation
8/15
AM Broadcast Standard
Highest ModulatingFrequency: 4.5kHz
Channel Bandwidth:
9kHz [10kHz USStandard]
Station Spacing: 4Channels
AM BroadcastBand: 535kHz to1605kHz
8/6/2019 6 Amplitude Modulation
9/15
AM BROADCAST BAND
Philippine AM Radio Broadcasting
8/6/2019 6 Amplitude Modulation
10/15
POWER RELATIONS IN THE AM WAVE
8/6/2019 6 Amplitude Modulation
11/15
SINGLE TONE MODULATION
8/6/2019 6 Amplitude Modulation
12/15
MULTITONE MODULATION
8/6/2019 6 Amplitude Modulation
13/15
PROBLEM SET 1
1. The tuned circuit of the oscillator in a simple AM transmitter employs a 50- Hcoil and a 1-nF capacitor. If the oscillator output is modulated by audiofrequencies up to 10kHz, what is the frequency range occupied by the sidebands?
2. The antenna current of an AM transmitter is 8A when only the carrier is sent, but
it increases to 8.93 A when the carrier is sinusoidally modulated. Find thepercentage modulation. Determine the antenna current when the depth of modulation is 0.8.
3. A 400W carrier is modulated on a depth of 75 percent; calculate the total powerin the modulated wave of standard AM signal.
4. A certain transmitter radiates 9kW with the carrier un-modulated, and 10.125 kW when the carrier is sinusoidally modulated. Calculate the modulation index. If another sine wave, corresponding to 40 percent modulation, is transmittedsimultaneously, determine the total radiated power.
8/6/2019 6 Amplitude Modulation
14/15
PROBLEM SET 2 FROM FREZNEL BOOK
8/6/2019 6 Amplitude Modulation
15/15