Post on 10-Apr-2018
+12v Constant = +12v Acc. Switch = -12v Chassis Ground= +12v Illumination = Antenna/Amp Remote = Can-Bus (H)=
Can-Bus (L)=LF+ =LF- =
RF+ = RF- = LR+ = LR- = RR+ = RR- =
Dash Type : Double DinAftermarket Type: Single/Double DinKit: GM1598BHarness: GM21SR/GM22SRAntenna Adapter: CRAB/CRARB
Interface Adapter(s): AXIPGMLAN
About the Vehicle
Make: BuickModel: LucerneYear: 2006-09
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Rear
Buick Lucerne
NOTES
Dimensions:
Dimensions: W= 8.5'' L= 5.75''D=
NOTES
Rear Deck: 6x9'' MidrangeSpeaker Adapter: SA69Speaker Harness: TBAFactory Assembly: (4) 9/32” bolts securing speaker.
Standard/OptionalCD playerIn-Dash 6 disc changerHarmon Kardon Sound System (280 watt)Navigation SystemSatellite Radio 6 Speaker SystemAux InputMP3 compatible
W= 5-5/8''L= 7-1/8''D= 2-7/8''
Type: Standard Audio System Location: At Speaker
Speaker Sizes
A Pillar: 1'' TweeterLowr Door: 6 1/2” MidrangeSpeaker Adapter: SAGMHR6Speaker Harness: TBAFactory Assembly: (1) 9/32” bolt securin speaker.
When installing aftermarket 5 ¼"or 6 ½" a speaker adapter is needed.
2006-09
Buick LucerneImages
Front Speakers
Radio removal
Front Speakers
Rear Speakers
1. Using a panel removal tool remove the trim bezelaround the radio and HVAC controls.2. Extract (3) 9/32" bolts securing the HVAC controlsto the dash. Disconnect and remove.3. Extract (4) 9/32" bolts securing the radio to the dash. Disconnect and remove.
Radio
Recommended: Disconnect negative battery cable
1. Using a PRT remove the screw cover located atthe top of the "A" pillar. Extract (1) PHS from behindthe screw cover.2. Pull the top of the "A" pillar out and then pull upwards to release it from the dash. Disconnectand remove.3. Using a PRT pry the tweeter out of the "A" pillar.
1. Using a small hook tool remove the screw coverlocated inside the door release handle trim bezel.Extract (1) PHS from behind that screw cover.2. Using a PRT remove the entire door panel.Disconnect and remove.3. Extract (1) 9/32" bolt securing the speakeradapter to the door steel. Disconnect and remove. to the door steel. Disconnect and remove
Rear Deck
"A" Pillar
Lower Door
1. Using a PRT remove the screw covers (1) on each "C" pillar) located at the top of the "C" pillar. Extract1 PHS from behind each screw cover. Using a PRTremove each "C" pillar.2. Using a PRT remove (2) panel fasteners each one is located behind the rear seat head rests. Pull the head rest back to expose the panel fasteners.3. Lift the entire rear deck up then pull it out toremove.4. Extract (4) 9/32" bolts securing the speaker to the rear deck. Disconnect and remove.
Rear Deck
Tweeter
2006-09