2005 Kawasaki ZX6R - PCIII USB - 1i218-411 www.powercommander.com

2005 Kawasaki ZX6RInstallation Instructions

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 (800) 992-4993 www.powercommander.com

Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Power Commander Decals2 Dynojet Decals2 Dual lock Velcro® Strip1 Alcohol Swab

You can also download the PowerCommander software and latest mapsfrom our web site at:

www.powercommander.com

The ignition MUST be turnedOFF before installation!

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Button Adjustment Display

Faceplate Buttons

USB PortExpansion Port

1. Remove the tail section byremoving the undertail andremoving the six screws for thetail section.

2 Prop the front of the fuel tankup.

3 Lay the PCIII in the tail sectionand route the harness along sidethe stock wiring harness towardsthe throttle bodies (Fig. B&C).

Fig.

AFi

g. B

Fig.

C

2005 Kawasaki ZX6R - PCIII USB - 2i218-411 www.powercommander.com

PCIII harness

PCIII harness

Remove these screws

4. Disconnect the stock wiring har-ness from the LOWER injectorsat the throttle bodies (Fig. D).

5. Plug the PCIII connectors in-lineof the stock injectors and wiringharness.

ORANGE - cylinder 1YELLOW - cylinder 2GREEN - cylinder 3BLUE - cylinder 4

6. Locate the Throttle PositionSensor connector behind thethrottle bodies. This is aWHITE 3 pin connector (Fig. F)

Fig.

DFi

g. E

Fig

F

2005 Kawasaki ZX6R - PCIII USB - 3i218-411 www.powercommander.com

PCIII connectors

TPS connector

Disconnect

Stock connectors

7. Plug the PCIII harness in-line ofthe stock wiring harness(Fig. G).

8. Attach the ground wire from thePCIII to the negative side of thebattery (Fig. H).

9 Bolt down the fuel tank.

10 Reinstall the tail section.

Fig.

GFi

g. H

2005 Kawasaki ZX6R - PCIII USB - 4i218-411 www.powercommander.com

PCIII connectors

Ground wire from PCIII

Stock connectors